- ページ 11

換気フード IKEA LBZ8CのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。IKEA LBZ8C 48 ページ。 30" (76.2 cm) range hood

5. Remove vent knockouts depending on your installation

requirements.

A. Round vent knockout

B. Top rectangular vent knockout

C. Rear rectangular vent knockout

Round vent system installations - Remove top rectangular

and round vent knockouts.

Rectangular vent system installations - For roof

installations, remove the top rectangular vent knockout. For

wall installations, remove the rear rectangular vent knockout.

Non-vent (recirculating) installations - Do not remove any

knockouts.

6. Install 7" (17.8 cm) round vent mounting plate or 3¹⁄₄" x 10"

(8.3 x 25.4 cm) vent damper, depending on your vent system

installation. Attach to range hood with 3.5 x 9.5 mm screws

provided.

NOTE: An optional 7" (17.8 cm) round damper is also

available as an accessory. For information on ordering, see

the "Accessories" section.

A. 7" (17.8 cm) round damper

(see "Accessories" section)

B. 3.5 x 9.5 mm screws

C. 7" (17.8 cm) round vent mounting plate

D. Round vent knockout

E. Rectangular vent knockout

NOTE: The 7" (17.8 cm) round vent mounting plate and

3¹⁄₄" x 10" (8.3 x 25.4 cm) rectangular vent connector can

be installed up to 1" (2.5 cm) on either side of the hood

center to accommodate off center ductwork.

A. Vertical connector

B. 3.5 x 9.5 mm screws

C. Vent knockouts

D. Horizontal connector

If a vent damper is installed with a wall cap with damper,

check that they do not interfere with each other. Remove

the vent connector damper flap if they interfere.

Non-vented (recirculating) installations - No vent

attachments. Removal of the recirculation cover plate is

required. Remove the two screws from the recirculation

cover plate and remove.

A. Screws

B. Recirculation cover plate