- ページ 5

冷蔵庫 Avantco 178SSPTM4812のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Avantco 178SSPTM4812 16 ページ。 Prep tables

ページを印刷する

Installation

This unit is intended for use in a temperature-controlled environment less than 75 degrees

Fahrenheit and 60% relative humidity. Malfunction due to improper conditions is not covered

under warranty.

IMPORTANT –

Please Read Before Installation:

•

If the shelf has a raised lip, the lip needs to be installed facing up towards the rear of the cabinet to

promote proper air flow. Failure to install the shelves properly is considered user error and is not

covered by warranty.

•

If the unit has recently been transported on its side, please let the unit stand still for a minimum of

24 hours before plugging it in.

•

Make sure that the unit has reached the desired temperature before loading the unit with products.

This unit is meant for keeping cold products cold, not chilling warm products.

•

Make sure that there is proper ventilation around the unit in the area where it will operate.

•

Make sure all accessories are installed (i.e., shelves, shelf clips, casters) before plugging the unit in.

•

Do not attempt to remove or repair any component of the unit. Consult an authorized service

technician for servicing/repair.

•

Do not hang on doors or stand inside the unit.

•

Do not store flammable, explosive, or corrosive liquids or gas in or near the cooler.

•

Please read through the manual in its entirety.

•

This unit is designed to perform in a temperature-controlled environment at 60% relative humidity.

The unit should be located away from doors, air ducts, and fans that could disrupt airflow and

negatively impact performance.

Cabinet Location Guidelines

•

Install the unit on strong and leveled surfaces.

- If the surface is uneven, the unit may be noisy.

- The unit may malfunction if the surface is uneven.

- Keep the cooler stable to avoid vibration and noise.

•

Install the unit in an indoor, well-ventilated area.

- For best performance, please maintain clearance of 3" on the back of the unit.

- Do not use outdoors. For indoor use only.

- Avoid direct sunlight.

- Unit should be placed far from any heating source to avoid decrease of refrigeration efficiency.

•

Avoid installation in a high humidity and/or dusty area.

- Humidity above 60% can cause the unit to rust, to collect condensation, and may decrease efficiency.

- Dust collected on condenser coil will cause unit to malfunction.

•

Malfunction due to temperatures above 75 degrees Fahrenheit, humidity above 60%, or improperly

maintained condenser coil will void the warranty.

User Manual

Refrigerated Prep Tables