- ページ 8

防犯カメラ Ganz zn-d9312nhaのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Ganz zn-d9312nha 12 ページ。 Zn-d9000 series network mini dome cameras

ページを印刷する

Connecting the cables

Connect the power cable and the LAN cable.

Attention

Check if the power supply is "OFF."

Connecting the power supply cable.

Connect the power cable (plug) included to the power source. In

the case of 12 V DC, connect the red cable to 12 V DC and the

black cable to the GND.

Connect the power cable (plug) connected in Step 1 above to the

power cable (jack) of the camera body.

Attention

When connecting the power source directly to the power input terminal of

the camera body without using the power cable (plug) included, be sure to

use a heat-resistant cable (resistant to the temperature higher than 75°C).

When connecting the 12 V DC power directly to the power input terminal

of the camera body without using the power cable (plug) included, be sure

to align "+12 V DC" with "GND" that are displayed near the terminal of the

board.

Connecting the LAN cable.

Connect the LAN cable to the LAN cable (jack) of the camera body.

When the LAN cable is connected, the LAN cable

connection conﬁ rmation LED (orange) lights up. The

LED (yellow) or (green) is ﬂ ashing according to Receive

and Transmit.

Connection conﬁ rmation (Orange)

DC12V

RED

BLACK

Receive (Yellow)

Transmit (Green)

EG-8

Attention

When the power is supplied at the same time from the PoE power source

and the power cable, the power cable line is used.

When the PoE power source is used, the connection of the power cable is

not required.

Use CLASS 2 power supply when you use 24 V AC.

Be sure to check that the cables are connected correctly before turning the

power on.

Turning on the power when the cables are connected with incorrect polarity

may damage the camera.

Be sure to use a LAN cable of category 5 or above.

Connection of I/O cables

When using an alarm and/or a speaker,

connect the I/O cables to the I/O cable

terminals provided on the camera body.

Wiring of I/O cable

1 (Brown) Input

2 (Red) GND

3 (Orange) Output

4 (Yellow) Output

Attention

"1" is an alarm input terminal with no-voltage make-contact input (3.3 V DC

pull-up resistor built-in, short circuit current is 0.4 mA).

"3" and "4" are alarm output terminals with contact output (30 V DC, 1 A

- 125 V AC 0.3 A).

5 (Green) Speaker (Output)

6 (Blue) GND

7 (Purple) Microphone (Input)

8 (Grey) GND