- ページ 2

防犯カメラ Ganz ZN-DNT352XE-MIRのPDF クイック・ユーザー・マニュアルをオンラインで閲覧またはダウンロードできます。Ganz ZN-DNT352XE-MIR 8 ページ。

Step2. Install IP device

To prevent products from damaging, place the camera on stable and non‐vibrating surfaces If

the stability is in doubt, consult with safety personnel for reinforcements, and then proceed

with the installation.

Caution

NC3502 Ver1.3

1) Place the installation template (paper)

that is included in the package on the

desired installation surface.

2) Drill three holes in correct positions

based on the template paper, and insert

anchor blocks into the holes.

Place the waterproof silicon band on the

bottom plate of the device and make it

align with screw holes.

Place the camera body to the

installation surface and match three

alignment holes with three anchor blocks.

Then tighten the surface anchor studs.

5) Connect all the required cables to the

camera.

Adjust the lens position.

7) Place the dome cover on the main body

of the camera. Dome cover has three

alignment holes that match camera body's

alignment holes.

8) Once properly placed, insert screws into

the three holes of the body and tighten

them up.