- ページ 8

換気フード IKEA W10177447BのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。IKEA W10177447B 32 ページ。 24" (61.0 cm)-30" (76.2 cm) wall-mount canopy range hood

ページを印刷する

It is recommended that the vent system be installed before

hood is installed.

Before making cutouts, make sure there is proper clearance

within the ceiling or wall for exhaust vent.

Check your ceiling height and the hood height maximum

before you select your hood.

1. Disconnect power.

2. Determine which venting method to use: roof, wall, or non-

vented.

3. Select a flat surface for assembling the range hood. Place

covering over that surface.

WARNING

Excessive Weight Hazard

Use two or more people to move and install

range hood.

Failure to do so can result in back or other injury.

4. Using 2 or more people, lift range hood onto covering.

Range Hood Mounting Screws Installation

5. Determine and mark the centerline on the wall where the

range hood will be installed.

6. Select a mounting height between a minimum of

30" (76.2 cm) and a suggested maximum of 36" (91.4 cm),

above the range to the bottom of the hood and mark

reference line on the wall.

NOTE: For installation locations with reduced ceilings

heights, the vent hood may be installed using the upper vent

cover for both vented and non-vented (recirculating)

installations.

7. Tape template in place, aligning the template centerline and

bottom of template with hood bottom line and with the

centerline marked on the wall.

A. Centerline

B. Mounting hook location

C. Fastener locations

D. Mounting height reference

INSTALLATION INSTRUCTIONS

Prepare Location

8. Mark centers of the 6 fastener locations through the template

to the wall.

IMPORTANT: All screws must be installed into wood.

Remove the template.

9. Drill ⁷⁄₆₄" (2.75 mm) pilot holes at all locations where screws

are being installed into wood.

10. Attach two mounting hooks to the wall at location marked on

the template.

A. Mounting hooks

B. Centerline on wall

Vent Cover Bracket Assembly and Installation

1. Assemble the three pieces of the vent cover bracket using the

four 4 X 8 mm screws provided. The assembled bracket

should be sized to fit inside the upper vent cover.

A. Vent cover bracket assembly

B. Upper vent cover

C. 4 X 8 mm screws

D. Adjustable width

2. Position vent cover bracket on wall about ¹⁄₈" (3.0 mm) away

from the ceiling.