- ページ 9

換気フード IKEA W10258591AのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。IKEA W10258591A 24 ページ。 30" (76.2 cm) vented range hood

ページを印刷する

7. Using 2 people, lift range hood into final position, feeding

electrical wire through wiring opening. Position the range

hood so that the large end of the keyhole slots are over the

screws. Then push the hood toward the wall so that the

screws are in the neck of the slots. Tighten mounting screws

to cabinet, making sure mounting screws are in narrow neck

of slots.

8. Check that the damper, if used, rotates up and down freely.

9. Connect ventwork to hood. Seal joints with clamps to make

secure and airtight.

_,.,.,,_£ S(,,_.,0t'

Fire Hazard

Electrically ground the blower.

Use copper wire.

Connect

ground wire to green ground screw in

terminaJ box.

Failure to do so can result in death, fire, or

electrical

shock.

Install 75-watt

(max.) Incandescent

Light Bulb

1. Squeeze the plastic lens cover and remove it from the hood.

A. Light bulb socket

B. Lens cover

2. Screw light bulb into socket.

3. Replace lens cover by squeezing cover and inserting tabs

into slots.

Check

Range

Hood Operation

1. Check light operation only by pressing light button.

2. Check operation of fan by pressing button to Hi and Lo

positions.

3. If the range hood does not operate, check to see whether a

circuit breaker has tripped or a house fuse has blown.

NOTE: To get the most efficient use from your new range hood,

read the "Range Hood Use" section.

Direct Wire Installation

Connect the white wire of the home power supply with the

white wire in the range hood using a UL listed twist-on

connector.

............

i.................

A. White wires

B. Black wires

C. Green ground screw

D. Ground wire

E. UL fisted or CSA approved strain relief

2. Connect the black wire of the home power supply with the

black wire in the range hood using a UL listed twist-on

connector.

3. Connect ground wire (green or bare) of home power supply to

the green ground screw in the terminal box.

Tighten strain relief screws.

Install the terminal box cover.

Reconnect power.