- ページ 4
食器洗い機 KitchenAid Architect II KUDC20CVのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。KitchenAid Architect II KUDC20CV 20 ページ。 Undercounter dishwasher
KitchenAid Architect II KUDC20CV にも： 製品寸法 (2 ページ)
ページを印刷する
Add Rinse Aid
■
Your dishwasher is designed to use rinse aid for good drying
performance. Without rinse aid your dishes and dishwasher
interior will have excessive moisture. The heat dry option will
not perform as well without rinse aid.
■
Rinse aid keeps water from forming droplets that can
dry as spots or streaks. They also improve drying by
allowing water to drain off of the dishes after the final
rinse.
■
Rinse aid helps to reduce excess moisture on the dish
racks and interior of your dishwasher.
■
Check the rinse aid indicator. Add rinse aid when indicator
drops to "Add" level.
■
To add rinse aid, turn the dispenser cap
to "Refill" and lift off. Pour rinse aid into
the opening until the indicator level is at
"Full." Replace the dispenser cap and
turn to "Lock." Make sure cap is fully
locked.
NOTE: For most water conditions, the
factory setting of 2 will give good
results. If you have hard water or notice
rings or spots, try a higher setting. Turn
the arrow adjuster inside the dispenser
by either using your fingers or inserting
a flat-blade screwdriver into the center
of the arrow and turning.
This information covers several different models. Your dishwasher may not have all the cycles and options described.
CYCLE SELECTIONS
CYCLES
DISH LOAD TYPES
Use for hard-to-clean, heavily
soiled pots, pans, casseroles,
and regular tableware.
Use for loads with normal
amounts of food soil.
Use for lightly soiled items or
china and crystal.
Use to quickly wash
prerinsed glasses or dish
loads.
Use for rinsing dishes,
glasses, and silverware that
will not be washed right away.
You can customize your cycle by selecting an option.
See option selections. If you change your mind, press the option again to turn off the option, or select a different option. You can change
an option anytime before the selected option begins.
*Maximum wash times depend on water temperature, heavy soil condition, dish load size and options selected.
4
Select a Cycle (cycles vary by model)
See "Cycle and Option Descriptions" charts in the following
section.
Heavier cycles and options affect cycle length. Some cycles and
Full
options will take up to 3
Add
Select Options (options vary by model)
See "Cycle and Option Descriptions" charts in the following
section.
You can customize your cycles by pressing the options desired.
Lock
6
Refill
Start or Resume a Cycle
■
turn to lock
■
6
■
Cycle and Option Descriptions
DESCRIPTIONS
During the wash, the wash action will
repeatedly pause for several seconds.
The energy-usage label is based on this
cycle. During the wash, the wash action
will repeatedly pause for several seconds.
During the wash, the wash action will
repeatedly pause for several seconds.
This cycle does not dry.
This cycle does not dry.
Do not use detergent.
STEP 3
hours to complete.
STEP 4
Run hot water at the sink nearest your dishwasher until the
water is hot. Turn off water.
Push door firmly closed. The door latches
automatically. Select the wash cycle and options
desired OR press START/RESUME to repeat the same
cycle and options as in the previous wash cycle.
You can add an item anytime before the main wash starts.
Open the door slowly and add the item. Close the door firmly.
Press START/RESUME.
Note: If the START/RESUME button is located on top of door,
push door firmly closed within 3 seconds of pressing START/
RESUME.
Cycle
Minimum
1:39
1:11
1:17
0:30
0:10
WASH TIME (HH:MM)
Cycle + Options
*Maximum
Minimum
2:09
3:30
1:41
3:30
1:47
2:51
none
none
none
none