- ページ 7
防犯カメラ HIKVISION TURBO HD DS-2CE56H0T-IT3FのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。HIKVISION TURBO HD DS-2CE56H0T-IT3F 17 ページ。 Turbo hd bullet & dome camera
HIKVISION TURBO HD DS-2CE56H0T-IT3F にも： ユーザーマニュアル (16 ページ)
ページを印刷する
6. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the camera according to the figure below
to get an optimum angle.
1). Loosen the P screw to adjust the pan position [0°
to 360°]. Tighten the screw after completing the
adjustment.
2). Loosen the T screw to adjust the tilt position [0°
to 180°]. Tighten the screw after completing the
adjustment.
3). Loosen the R screw to rotate the camera [0° to
360°]. Tighten the screw after completing the
adjustment.
2.2 Ceiling/Wall Mounting of Type II Camera
Steps:
1. Paste the drill template (supplied) to the place
where you want to install the camera.
2. Drill the screw holes according to the drill template,
and the cable hole (optional) on the ceiling.
Note:
Drill the cable hole in the center of the drill template,
when adopting ceiling outlet to route the cable.
3. Route the cables through the cable hole (optional)
or the side opening.
4. Fix the camera to the ceiling with supplied screws.
Figure 2-5 Fix the Camera to the Ceiling
Note:
The supplied screw package contains self-tapping
screws, and expansion bolts.
For cement wall/ceiling, expansion bolts are
required to fix the camera. For wooden
wall/ceiling, self-tapping screws are required.
Figure 2-3 3-axis Adjustment
Figure 2-4 Drill Template
Screw
Hole