- ページ 16

食器洗い機 KitchenAid BRIVA KIDS01EKのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。KitchenAid BRIVA KIDS01EK 20 ページ。 In-sink dishwasher

ページを印刷する

Drain Air Gap

Check the drain air gap anytime your dishwasher isn't draining

well.

If a drain is clogged, the drain air gap protects your dishwasher

from water backing up into it.

To clean the drain air gap

Clean the drain air gap periodically to ensure proper drainage of

your dishwasher. Lift off the outer cover. Unscrew the plastic cap.

Then check for any soil buildup. Clean if necessary.

NOTE: The fill air gap is located to the right of the drain air gap

and does not require maintenance.

Storing

Storing for the summer

Protect your dishwasher during the summer months by turning

off the water supply and power supply to the dishwasher.

Winterizing your dishwasher

Protect your dishwasher and home against water damage due to

freezing water lines. If your dishwasher is left in a seasonal

dwelling or could be exposed to near freezing temperatures, have

your dishwasher winterized by authorized service personnel.

TROUBLESHOOTING

First try the solutions suggested here and possibly avoid

the cost of a service call...

Dishwasher is not operating properly

Dishwasher does not run or stops during a cycle

Is the lid closed tightly and latched?

Is the right cycle selected? Refer to the "Cycle Selection

Charts."

Is there power to the dishwasher? Has a household fuse

blown or circuit breaker tripped?

Has the Ground Fault Circuit Interruptor (GFCI) tripped?

Press the Reset button. Indicator should be visible inside the

indicator window. Refer to the "Before Using Your

Dishwasher" section. If the GFCI does not reset, call for

service.

Has the motor stopped due to an overload? The motor

automatically resets itself within a few minutes. If it does not

restart, call for service.

Is the Drain stopper closed? If it is not closed properly,

selected cycle immediately ends, lid pops open, and Check

Drain indicator is lit.

Dishwasher will not fill

Is the water shut-off valve (if installed) turned on?

Dishwasher seems to run too long

Is the water supplied to the dishwasher hot enough? The

dishwasher runs longer while heating water. Refer to the

"Dishwasher Performance Tips" section.

A delay automatically occurs in some wash and rinse cycles

until the water reaches the proper temperature.

Water remains in the dishwasher

Is the cycle complete?

Odor in the dishwasher

Are dishes washed only every 2 or 3 days? Run a rinse cycle

once or twice a day until you have a full load.

Does the dishwasher have a new plastic smell? Run a vinegar

rinse as described in "Spotting and filming on dishes" later in

this Troubleshooting guide.

Dishes are not completely clean

Food soil left on the dishes

Is the dishwasher loaded correctly? Refer to the "Dishwasher

Loading" section.

Is the water temperature too low? For best dishwashing

results, water should be 120°F (49°C) as it enters the

dishwasher. Refer to the "Dishwasher Performance

Tips" section.