- ページ 10

防犯カメラ HIKVISION U1T SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。HIKVISION U1T Series 16 ページ。 Turbo hd turret & dome camera
HIKVISION U1T Series にも：ユーザーマニュアル (15 ページ)

ページを印刷する

For cement wall/ceiling, expansion bolts are



required to fix the camera. For wooden wall/ceiling,

self-tapping screws are required.

6. Route the cables through the cable hole, or the side

opening.

7. Secure the camera on the mounting base.

1） pull out the clip plate, and then to combine the

camera with the mounting base.

2） Push the clip plate in, and secure the camera by

tightening the screw.

8. Connect the corresponding cables, such as power

cord, and video cable.

9. Power on the camera to check whether the image on

the monitor is gotten from the optimum angle. If not,

adjust the camera according to the figure below to get

an optimum angle.

1). Hold the camera body and rotate the enclosure to

adjust the pan position [0° to 360°].

2). Move the camera body up and down to adjust the

tilt position [0° to 75°].

3). Rotate the camera body to adjust the rotation

position [0° to 360°].

Note:

Loose the screw on the mounting base before

adjusting the monitoring angle.

2.4 Ceiling Mounting of Type IV Camera

Steps:

1. Paste the dill template to the ceiling.

2. Drill the screw holes and cable hole (optional) in the

ceiling according to the drill template.

Figure 2-14 Secure the Camera

Figure 2-15 3-axis Adjustment

Drill Template

Hole A: for cables routed through the ceiling

screw hole 1: for Mounting Base

Figure 2-16 Drill Template

Screw

Hole

Cable

Hole