- ページ 9

食器洗い機 KitchenAid KDFX 6050のPDF 製品シートをオンラインで閲覧またはダウンロードできます。KitchenAid KDFX 6050 16 ページ。

Only use rinse aids recommended for use in domestic dishwashers. If rinse aid is accidentally spilt,

immediately remove it to avoid the formation of excessive suds which could cause appliance

malfunctioning.

c. How to adjust the rinse aid dosage regulator:

- The rinse aid dosage can be adjusted to the detergent used. The lower the

setting, the less rinse aid is dispensed (factory setting: position 4).

- Press the button 2 to open the cover.

- Using a coin or similar object, turn the arrow to the desired setting.

- After adjusting the rinse aid setting, shut the cover again.

If the dishes often have whitish streaks: reduce the dosage by turning the dial to a lower setting (1-

3). Dishes did not dry: increase the dosage by turning the dial to a higher setting (5-6). Plastic

dishes have more difficulty drying and a higher rinse aid setting will not improve the situation.

HOW TO CHECK/FILL/ADJUST SALT

Only use regeneration salt specifically intended for dishwashers.

a. How to check the salt level

Depending on the model, check the visual indicator

window on the salt reservoir cap is clear when salt needs to

be added and coloured when the salt present is sufficient. In

the case of appliances with an electric indicator on the control

panel, the salt indicator

cycle when salt needs to be added.

b. How to fill the salt container

- Remove the lower rack.

- Turn the salt container cap anti-clockwise to open it.

- When using the dishwasher for the first time, fill the salt

container to the rim with water.

- To make sure no grains of salt touch the stainless steel

components, fill the salt container up to the rim using a

funnel (when filling for the first time, use min. 0.8 kg and

max. 1kg).

- Stir with the handle of a wooden spoon to help dissolve the

salt.

- Close the cap of the salt container by turning it clockwise.

- Fit the lower rack.

Once regeneration salt is added, immediately start a wash programme (the "Pre-wash"

programme alone is not sufficient). Residual saline solution or grains of salt can lead to deepdown

corrosion, irreparably damaging the stainless steel components. The guarantee is not applicable if

faults are caused by such circumstances.

The salt level indicator lamp may remain lit at the end of several wash cycles. If the water hardness

level falls within category 1 (soft), no salt is required.

lights up at the end of the wash

. The