- ページ 4
家庭用照明 IKEA OBEGRANSADのPDF マニュアルをオンラインで閲覧またはダウンロードできます。IKEA OBEGRANSAD 8 ページ。
IKEA OBEGRANSAD にも： マニュアル (48 ページ), マニュアル (33 ページ)
ページを印刷する
English
Before use
•
Choose placement. Avoid placing the record player
in direct sunlight or near any heat source. Also
avoid locations subject to vibrations and excessive
dust, heat, cold or moisture.
•
The record player is designed to operate in a
horizontal position only.
•
If the record player is brought directly from a cold
or warm location, moisture may condense inside
the player and cause damage. When you first
install the player, or when you move it from a cold
to a warm location – wait for 30 minutes before
starting the player.
Installation
•
Connect the included RCA-cable (3.5 mm) to your
stereo.
•
Connect the included USB cable to a power source.
Features
•
Outputs for RCA cables, so you can connect the
record player to your speaker or stereo.
Parts
1. USB cable
2. RCA cable (3.5 mm)
3. Turntable
4. Tone arm and stylus
5. Lifter for tone arm
6. RCA output
7. USB input
8. Tone arm rest and security latch
9. Power switch
10. Speed switch
11. Cartridge/stylus
Caution
•
To avoid stylus damage, ensure that the included
stylus guard is in place when the record player is
being installed, moved or cleaned.
•
No naked flame sources, such as lighted candles,
should be placed on the apparatus.
•
temperature operating 0-40 degrees
•
Prior to moving the turntable – always unplug it
from the power outlet and fasten the tone arm by
using the security latch.
•
To prevent fire or electric shock, disconnect the
unit from the power source when cleaning.
•
Use caution when cleaning and wiping the player.
How to play vinyl records
1. Place the vinyl record on the turntable.
2. Press power switch to 'on'.
3. Choose 33 or 45 RPM by using the speed switch.
4. Loosen the security latch.
5. Lift the tone arm, move it over the record and
lower it. The record now starts playing.
6. When finished – raise the tone arm, move it back to
the rest and lower the arm.
4
Cleaning
•
Do not touch the stylus tip with your fingers, avoid
bumping the stylus on the turntable's mat or on a
record´s edge.
•
Clean the stylus tip frequently, using a soft brush
with a back-to-front motion only. If you use a stylus
cleaning fluid, use it very sparingly.
•
Wipe the turntable housing gently with a soft cloth.
Use only a small amount of mild detergent solution
to clean the turntable.
Other
This device complies with part 15 of the FCC Rules
((Federal Communications Commission Statement).
Operation is subject to the following conditions: (1) this
device may not cause harmful interference and (2) this
device shall accept any interference received, including
interference that may cause undesired operation.
WARNING:
Any changes or modifications to this unit not expressly
approved by the party responsible for compliance
could void the user's authority to operate the
equipment.
Note: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment
and receiver.
•
Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV
technician for help.
For indoor use only.