- ページ 9

トレッドミル Decora Y600 SeriesのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Decora Y600 Series 13 ページ。 Self-powered treadmill

miles) and observe the position of the walking belt. If the walking belt

moves to the right, turn the right bolt ¼ turn clockwise to tighten it, and

loosen the left bolt ¼ turn. If the walking belt moves to the left, turn the

left bolt ¼ turn clockwise to tighten it, and loosen the right bolt ¼ turn.

Repeat step 3 until the walking belt remains in the center for several

minutes.

4. Check the tightness of the walking belt. The walking belt should be

very tight. The walking belt should not be sluggish or slippery when

walking or running on it.

Please note: Please make sure that the walking belt is centered before

using it, as shown in the figure. Please adjust the walking belt until the

edge of the walking belt is parallel to the decorative strips on both sides.

First loosen the two M8 bolts with an 8mm Allen wrench, then tighten / loose them clockwise /

counterclockwise with a 14mm open-end wrench, and then tighten the two M8 bolts.

Turn clockwise to tighten backwards and counterclockwise to loosen forward;

note!

When making corrections, do not run faster than 4.8 kilometers per hour (3 miles). Be

careful not to get your fingers, hair, and clothing near the walking belt