- ページ 7

食器洗い機 KitchenAid KDTM354DSSのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。KitchenAid KDTM354DSS 17 ページ。

First try the solutions suggested here. If you need further assistance or more recommendations that may help you to avoid a service call, refer to

the warranty page in this manual and scan the code with your mobile device, or visit https://www.kitchenaid.com/product_help. In Canada, visit

http://www.kitchenaid.ca

In the U.S.A.:

KitchenAid Brand Home Appliances

Customer eXperience Center

553 Benson Road

Benton Harbor, MI 49022-2692

Please include a daytime phone number in your correspondence.

If you experience

The Clean light is

Check the following:

flashing

Is the overfill protection float able to move up and down freely? Press down to release.

Be sure the water supply is turned on to the dishwasher. (This is very important following the new installation of your

dishwasher.)

Check for suds in the dishwasher. For more information on suds, see "Dishwasher does not clean completely."

Dishes do not dry

NOTE: Plastic and items with nonstick surfaces are difficult to dry because they have a porous surface, which tends to

completely

collect water droplets. Towel drying may be necessary.

Use of rinse aid along with the ProDry™ option is needed for proper drying.

Proper loading of items can affect drying.

For improved results, place items on the more slanted side of the rack.

Glasses and cups with concave bottoms hold water. This water may spill onto other items when you are unloading the

dishwasher.

Unload the bottom rack first.

Spotting/Filming

NOTES:

Liquid rinse aid is necessary for drying and to reduce spotting.

Use the correct amount of detergent.

Confirm that the cloudiness is removable by soaking the item in white vinegar for 5 minutes. If the cloudiness disappears, it

is due to hard water. Adjust the amount of detergent and rinse aid (see "Dishwasher Care" section). If it does not come

clear, it is due to etching.

Be sure the incoming water temperature is set at 120°F (49°C).

Try using the Hi-Temp Wash or Sani Rinse options.

To remove spotting, see "Dishwasher Care" section.

Dishwasher does

Be sure the dishwasher is loaded correctly. Improper loading can greatly decrease the washing performance (see the

not clean

"Operating Your Dishwasher" section).

completely

Select the proper cycle for the type of soils. The ProWash™ or Tough cycle can be used for tougher loads.

Be sure the incoming water temperature is at least 120°F (49°C).

Use the proper amount of fresh detergent. More detergent is needed for heavier-soiled loads and hard water conditions.

Scrape food from dishes prior to loading (do not prerinse).

If foam or suds are detected by the dishwasher sensing system, the dishwasher may not operate properly or may not fill

with water.

Suds can come from:

Using the incorrect type of detergent, such laundry detergent, hand soap, or dish detergent for hand washing dishes.

Not replacing the rinse aid dispenser cap after filling (or refilling) the rinse aid.

Using an excessive amount of dishwasher detergent.

PROBLEM SOLVER

In Canada:

KitchenAid Brand Home Appliances

Customer eXperience Centre

200 - 6750 Century Ave.

Mississauga, Ontario L5N 0B7