- ページ 4

ストーブ decorflame QC210-BKのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。decorflame QC210-BK 6 ページ。 Electric stove heater

ページを印刷する

After completely reading instructions, confirm

that all controls on stove are in the off position.

Plug the unit into a 15 amp, 120 volt outlet.

OPERATION

Controls and switches are located on front

panel inside the glass door.

FLAME: Press this button into the I position

for main power and flame effect. The indicator

light will turn on. See below for other control

switches.

HEATINg: For heat function - Press this switch

while the FLAME switch is in the I position for

heat. The indicator light will turn on.

THERMOSTAT: To adjust the temperature to

your individual requirements. Turn the thermo-

stat dial to the right (clockwise) to increase the

desired temperature and to the left for lower

temperature. This thermostat control dial can

only be used while the FLAME switch and

HEATINg switches are in the I position.

When the heater reaches the desired tempera-

ture, the heater and Heating indicator light will

turn off but the fan will continue to operate.

Adjust this knob to restart the heater.

NOTE: When the FLAME switch is turned in

the O position, all other heater functions will

stop even though the switches may be in the I

position.

O P E R A T I O N

THERMOSTAT CONTROL

The heat output is controlled by the thermostat,

according to the room temperature. Set the

thermostat dial fully clockwise to the

maximum position initially.

When the room is warm enough, reduce the

setting by slowly turning the thermostat dial

counter-clockwise until the heater clicks OFF.

This will then maintain the room

temperature at the desired level.

CAUTION

If you use this heater in conjunction with a

thermal control, a program controller, a timer

or any other device that switches on the heater

automatically, remember to observe all safety

warnings at all times.

The stove heater has a safety overheat

protection. If the overheat protection trips,

turn off the FLAME switch and unplug the

power cord from the receptacle. It should

reset automatically after 5 minutes.