ヒーター decorflame DS502-SLのPDF マニュアルをオンラインで閲覧またはダウンロードできます。decorflame DS502-SL 9 ページ。 Oscillating fireplace heater

ページを印刷する

iMpOrtant:

nOte: DO nOt retUrn Unit tO the stOre

BefOre cOntacting OUr cUstOMer serVice

DepartMent. DO nOt DispOse Of yOUr cartOn

Until yOU are cOMpletely satisfieD with

yOUr new Oscillating fireplace heater.

please nOte: when yOU Open the cartOn carefUlly check

the Unit anD Make sUre there is nO DaMage. if yOU haVe

any prOBleMs with asseMBling the Unit, with hOw the

VariOUs fUnctiOns wOrk Or with DaMage Or Missing parts,

please gO tO OUr weBsite www.qUalitycraft.cOM anD

click On cUstOMer sUppOrt.

nOte: light bulbs may become loose during shipping. if the flame effect is dim or does not

work, please check that light bulb or bulbs are finger tight in socket. see instructions for

replacing bulb or bulbs.

INSTRUCTION MANUAL

attentiOn:

1. Find a location for the heater that is protected from direct sunlight.

2. Do not plug the unit into the power outlet before reading all instructions.

IMPORTANT SAFETY

INSTRUCTIONS

when Using electrical appliances, Basic precaUtiOns shOUlD always Be

fOllOweD tO reDUce the risk Of fire, electric shOck, anD inJUry tO persOns,

inclUDing the fOllOwing:

1) read all instructions before using this heater.

2) this heater is hot when in use. to avoid burns, do not let bare skin touch hot surfaces.

the grill directly in front of the heater outlet becomes hot during heater operation. keep

combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains

at least 3 ft (0.9 m) away from the front of the unit and keep them away from the sides and

rear.

3) extreme caution is necessary when any heater is used by or near children or individuals

with disabilities and whenever the fireplace is left operating and unattended.

4) always unplug the heater when not in use.

5) Do not operate any heater with a damaged cord or plug or after the heater malfunctions,

has been dropped or damaged in any manner.

6) Do not use outdoors.

Oscillating

fireplace heater

Model: DS502-SL

7) this heater is not intended for use in bathrooms, laundry areas and similar indoor

locations. never locate heater where it may fall into a bathtub or other water container.

8) Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar

coverings. arrange cord away from traffic area and where it will not be tripped over.

9) to disconnect heater, turn controls to off, then remove plug from outlet.

10) connect to properly grounded outlets only.

11) Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this

may cause an electric shock or fire, or damage the heater.

12) to prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on

soft surfaces, like a bed, where openings may become blocked.

13) a heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline,

paint, or flammable liquids are used or stored.

14) Use this heater only as described in this manual. any other use not recommended by the

manufacturer may cause fire, electric shock, or injury to persons.

15) caution: Do not plug this product into a receptacle controlled by a wall switch or dimmer.

16) when storing or transporting the unit and cord, keep in a dry place, free from excessive

vibration and store so as to avoid damage.

SAVE THESE INSTRUCTIONS

FOR FUTURE USE.

caUtiOn: if yOU Use this heater in cOnJUnctiOn with a therMal cOntrOl, a

prOgraM cOntrOller, a tiMer Or any Other DeVice that switches the heater

On aUtOMatically, reMeMBer tO OBserVe all safety warnings at all tiMes. the

fireplace heater has safety OVerheat prOtectiOn. if the OVerheat prOtectiOn

trips, switch Off all switch BUttOns anD wait apprOxiMately 5-10 MinUtes. it

shOUlD reset aUtOMatically Once the Unit cOOls DOwn.

warning: prOceDUres anD techniqUes if nOt carefUlly fOllOweD will resUlt in

DaMage tO the eqUipMent anD will expOse the User tO the risk Of seriOUs inJUry,

illness Or Death.

A 15 AMP circuit is required to operate this heater. If the breaker trips when the heater

is used, then you may need to move the heater to another location or unplug other

appliances that are on the same circuit. If you require an extension cord use one that is

rated at 1875 watts.