- ページ 3
自転車 Green Speed GT SeriesのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Green Speed GT Series 14 ページ。
ページを印刷する
Tools Required for Assembly
The trike's main feature is its ability to be folded
/ assembled with the minimum of tools / effort.
Frame Assembly
Assembly of the folding trike is as follows. If you are assembling from a boxed state, you start by
unpacking it all carefully. Once all the packaging has been removed, the fun bit begins.
The frame is now ready to unfold. Start by holding the back section
and lifting it away from the frame and straightening the frame out.
Note the quick release needs to be rotated all the way forward (pic
1) for the safety pin to be released to allow the frame to unfold all
the way. Once it has been unfolded all the way, you rotate the
Quick Release rearward and tighten it up.
Wheels
Outside spoke
pointing left
Left Side Wheel
brake hub. The brake assembly (Pic. 2.2) may need some re-centring for the wheel to slide all the
way on. Use the provided short cap screw (Pic. 2.3) to hold the wheel on. Do the same on the other
side. Disc wheels will then need the calipers installed. Start with the forward most screw and
Pic. 2.2
Important. If you are unfamiliar with a quick release mechanism, PLEASE get a Greenspeed Dealer or local
bike shop/friend show you the finer points of safe use. The quick release on the frame is slightly different to
a wheel quick release in that it requires a 10mm wrench to add tightness to it should the adjustment loosen
of with time/wear. Please keep it tight enough that you can release/tighten with moderate hand effort.
Fig. 2.1
Look at
the top
of the hub
Right Side Wheel
Pic. 2.3
6,5 and 4mm
Allen keys
2x 9 and a 24mm wrench
Next
wheels.
Outside spoke
wheel in first and tighten
up the quick release. Now
pointing right
install the front wheels.
Fig 2.1 shows that there
are left and right wheels.
The right hand wheel has
been tagged for your
reference. Be sure to try
and install them
way in the future to
increase spoke life. The
front hubs shown are
drum brakes, and it is the
same
Pic. 2.4
Assembly
you
install
the
Put the rear
this
priniple
when