- ページ 4

食器洗い機 KitchenAid KUDD01DPPA0のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。KitchenAid KUDD01DPPA0 16 ページ。 Drawer dishwasher

ページを印刷する

Cabinet

dimensions/requirements

moisture

protection tape

For dishwasher:

[] Not water line with 4.3-145 psi (30-1000 kPa) water pressure.

[] 120°F (48.8°C) water at dishwasher.

[] An easily accessible valve with 3/8" compression fitting must

be installed in the hot water supply line.

C-.'.'

C.'

Utility hole:

1-1/2"(3_8 crn)din.

hole,

eitherside

immediately

adjacent

tocorner. \

\\\\\\\

4 ,_

(10cm)

32-5/16 "- 34-5/8"

(82_0 cm - 88_0 cm)

22-7/8"

(58.0cm)

23-5/8"* (60_0 cm)

Emectrical Shock Hazard

Plug into a grounded

3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension

cord.

Failure to follow these instructions

can result in death,

fire, or electrical

shock.

typical

installation

1/2" (12,7 ram) from

front of countertop

moisture

protection

tape

The 3 prong grounded outlet must be installed within 6"

(15.2 cm) to 18" (45.7 cm) of the cabinet side wall.

NOTE: The power outlet must be accessibIe after installation.

it is recommended that wood cabinetry surrounding the

dishwasher be sealed with an oil-based paint or moisture-proof

polyurethane to prevent possibIe damage from humidity.

The utility hole must be located as shown, if the hole is not

located as shown, the hoses will prevent the dishwasher from

being pushed back all the way into the cavity. Make sure the

edges of the utility hole are smooth or covered, if the utility hole

is through a metal cabinet, the hole must be protected with the

edge protector provided.

*IMPORTANT: Custom wood door panels, if used, may be wider

than the dishwasher to match surrounding cabinets. The 23-5/8"

(60.0 cm) must be increased so that there is a 1/4" (6.4 mm)

clearance between the cabinet side and panel edge.

For corner installation, there must be a !/2" (12.7 mm) space

between the adjacent cabinet doors (Le. door knobs) and open

dishwasher drawer.

GROUNDmNG

mNSTRUCTmONS

For a grounded,

cord-connected

dishwasher:

The dishwasher

must be grounded.

In the event of a

malfunction or breakdown,

grounding will reduce the risk of

electric shock by providing a path of least resistance for

electric current. The dishwasher

is equipped with a cord

having an equipment-ground

conductor

and a grounding

plug. The plug must be plugged into an appropriate

outlet

that is installed and grounded in accordance

with all loca!

codes and ordinances.

WARNUNG:

Improper connection of the equipment-

grounding conductor can result in a risk of electric shock.

Check with a qualified electrician or service representative if

you are in doubt whether the dishwasher is properiy

grounded. Do not modify the plug provided with the

dishwasher; if it will not fit the outlet, have a proper outlet

installed by a qualified electrician.

For a permanentBy connected

dishwasher:

The dishwasher must be connected to a grounded metal,

permanent wiring system, or an equipment-grounding

conductor must be run with the circuit conductors and

connected to the equipment-grounding

terminat or lead on

the dishwasher.

SAVE THESE

mNSTRUCTmONS

A 120-volt, 60 Nz, AC-onty, 15 amp fused electrica! supply is

required. (Circuit breaker or time-delay fuse is recommended.)

is recommended that a separate circuit serving only this

appliance be provided.