- ページ 5
DVR HIKVISION DS-2CE16D8T-IT3のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。HIKVISION DS-2CE16D8T-IT3 15 ページ。 Turret cameras turbo hd d8t series
HIKVISION DS-2CE16D8T-IT3 にも： クイック・スタート・マニュアル (17 ページ), ユーザーマニュアル (15 ページ)
ページを印刷する
If the wall is cement, insert expansion screws before
installing the camera. If the wall is wooden, use
self-tapping screw to secure the camera.
If the product does not function properly, contact
your dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance by
yourself.
2.1 Installation of Type I Camera
2.1.1 Ceiling/Wall Mounting without Junction Box
Steps:
1. Disassemble the turret camera by rotating the
camera to align the notch to one of the marks, as
shown in the figure below.
Figure 2-1 Disassemble the Camera
2. Remove the mounting base from the camera body
with a flat object, e.g., a coin.
3. Paste the drill template (supplied) to the place
where you want to install the camera.
4. Drill the screw holes and the cable hole (optional)
on the ceiling/wall according to the drill template.
Note:
Drill the cable hole, when adopting the ceiling outlet
to route the cable
5. Attach the mounting base to the ceiling/wall, and
secure them with supplied screws
Figure 2-3 Attach the Mounting Base to the Ceiling
Note:
The supplied screw package contains self-tapping
screws, and expansion bolts.
For cement wall/ceiling, expansion bolts are
required to fix the camera. For wooden wall/ceiling,
self-tapping screws are required.
6. Route the cables through the cable hole, or the side
opening.
7. Align the camera with the mounting base, and
tighten the screws to secure the camera on the
mounting base.
Figure 2-2 Drill Template
Mark
Notch