- ページ 6

ストーブ Green Stoves 8kWのPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。Green Stoves 8kW 14 ページ。 Freestanding boiler stoves

The outlet from the chimney should be above the roof of the building in accordance with the provisions of

Building Regulations Approved Document J.

If installation is into an existing chimney then it must be sound and have no cracks or other faults which might

allow fumes into the house. Older properties, especially, may have chimney faults or the cross section may be

too large i.e. more than 230 mm x 230 mm. Remedial action should be taken, if required, seeking expert advice,

if necessary. If it is found necessary to line the chimney then a flue liner suitable for solid fuel must be used in

accordance with Building Regulations Approved Document J.

Any existing chimney must be clear of obstruction and have been swept clean immediately before installation of

the stove. If the stove is fitted in place of an open fire then the chimney should be swept one month after

installation to clear any soot falls which may have occurred due to the difference in combustion between the

stove and the open fire.

If there is no existing chimney then any new system must be to the designation described above and in

accordance with Building Regulations Approved Document J.

A single wall metal fluepipe is suitable for connecting the stove to the chimney but is not suitable for use as the

complete chimney. The chimney and connecting fluepipe must have a minimum diameter of 150 mm and its

dimension should at no point be less than the size of the outlet socket of the stove.

Any bend in the chimney or connecting fluepipe should not exceed 45°. 90° bends should not be used.

Combustible material should not be located where the heat dissipating through the walls of fireplaces or flues

could ignite it. Therefore when installing the stove in the presence of combustible materials due account must

be taken of the guidance on the separation of combustible material given in Building Regulations Approved

Document J and also in these stove instructions.

If it is found that there is excessive draught in the chimney then a draught stabiliser should be fitted.

Adequate provision e.g. easily accessible soot door or doors must be provided for sweeping the chimney and

connecting fluepipe.

Hearth

The hearth should be able to accommodate the weight of the stove and its chimney if the chimney is not

independently supported. The weight of the stove is indicated in the brochure.

The stove should preferably be installed on a non-combustible hearth of a size and construction that is in

accordance with the provisions of the current Building Regulations Approved Document J.

The clearance distances to combustible material beneath, surrounding or upon the hearth and walls adjacent to

the hearth should comply with the guidance on the separation of combustible material given in Building

Regulations Approved Document J and also in these stove instructions.

If the stove is to be installed on a combustible floor surface, it must be covered with a non-combustible material

at least 12mm thick, in accordance with Building Regulations Approved Document J, to a distance of 30 cm in

front of the stove and 15 cm to each side measuring from the door of the combustion chamber.