- ページ 5

DVR HIKVISION DS-2CE56D8T-IT3EのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。HIKVISION DS-2CE56D8T-IT3E 15 ページ。 Bullet & turret camera
HIKVISION DS-2CE56D8T-IT3E にも：ユーザーマニュアル (17 ページ), クイック・スタート・マニュアル (17 ページ)

ページを印刷する

If the wall is cement, insert expansion screws before



installing the camera. If the wall is wooden, use

self-tapping screw to secure the camera.

If the product does not function properly, contact



your dealer or the nearest service center. Do NOT

disassemble the camera for repair or maintenance by

yourself.

2.1 Installation of Type I Camera

2.1.1 Ceiling/Wall Mounting without Junction Box

Steps:

1. Disassemble the turret camera by rotating the

camera to align the notch to one of the marks, as

shown in the figure below.

Figure 2-1 Disassemble the Camera

2. Remove the mounting base from the camera body

with a flat object, e.g., a coin.

3. Paste the drill template (supplied) to the place

where you want to install the camera.

4. Drill the screw holes and the cable hole (optional)

on the ceiling/wall according to the drill template.

Note:

Drill the cable hole, when adopting the ceiling outlet

to route the cable

5. Attach the mounting base to the ceiling/wall, and

secure them with supplied screws

Figure 2-3 Attach the Mounting Base to the Ceiling

Note:

The supplied screw package contains self-tapping



screws, and expansion bolts.

For cement wall/ceiling, expansion bolts are



required to fix the camera. For wooden wall/ceiling,

self-tapping screws are required.

6. Route the cables through the cable hole, or the side

opening.

7. Align the camera with the mounting base, and

tighten the screws to secure the camera on the

mounting base.

Figure 2-2 Drill Template

Mark

Notch