- ページ 4

業務用食品機器 Avantco 224BCD48SBのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Avantco 224BCD48SB 7 ページ。 Refrigeration square bakery cases

User Manual

Installation

Please read this manual thoroughly prior to equipment set-up, operation, and maintenance.

This unit is intended for use in a temperature-controlled environment less than 75°F and 55%

relative humidity. Malfunction due to improper conditions is not covered under warranty.

Important!!! Please Read Before Installation

• If the unit has recently been transported on its side, please let the unit stand upright for a

minimum of 24 hours before plugging it in.

• Make sure all accessories are installed (shelves, shelf clips, etc...) before plugging in the unit.

• Make sure the unit has reached the desired temperature before loading the unit with products.

• Do not attempt to remove or repair any component of the unit. Consult an authorized service

technician for servicing / repair.

• Do not hang on doors or stand inside the unit.

• Please read through this manual in its entirety.

Cabinet Location Guidelines

• Install the unit on a strong and leveled surface.

- If the surface is uneven, the unit may be noisy.

- The unit may malfunction if the surface is uneven.

• Install the unit in an indoor, well-ventilated area.

- For best performance, maintain 6" of clearance on the sides and the back of the unit at all times.

- Outdoor use may cause decreased efficiency and damage to the unit.

- Avoid direct sunlight.

• Avoid installation in a high humidity and / or dusty area.

- High humidity can cause the unit to rust and may decrease efficiency.

- Dust collected on the condenser coil may cause unit to malfunction.

- Malfunction due to high ambient temperatures, humidity, or improperly maintained

condenser coil will void the warranty.

• Select a location away from heat and moisture-generating equipment.

- High ambient temperatures may cause the compressor to malfunction.

- Malfunction due to high ambient temperatures and humidity will void the warranty.

• If your model is refrigerated, the unit is designed to perform in a temperature-controlled

environment less than 75°F and 55% relative humidity. The unit should be located away from

doors, air ducts, and fans that could disrupt airflow and negatively impact performance.

- 4 -