ページを印刷する
ENGLISH
All local waterboard regulations must be
complied with.
Water supply pressure 0.05 - 1.0 MPa.
The appliance must be placed against
the wall or built into furniture to limit the
access to its rearside.
For dishwashers having ventilation
openings in the base, the openings must
not be obstructed by a carpet.
If installing the dishwasher at the end
of a row of units making the side panel
accessible, the hinge area must be covered
to avoid risk of injury.
The inlet water temperature depends on
the dishwasher model. If the installed inlet
hose is marked "25°C Max", the maximum
allowed water temperature is 25°C. For all
other models the maximum allowed water
temperature is 60°C. Do not cut hoses
and, in the case of appliances fitted with
a waterstop system, do not immerse the
plastic casing containing the inlet hose
in water. If hoses are not long enough,
contact your local dealer. Make sure the
inlet and drain hoses are kink-free and are
not crushed. Before using the applinace
for the first time, check the water inlet and
drain hose for leaks. Make sure that the
four feet are stable and resting on the floor,
adjusting them as required, and check that
the dishwasher is perfectly levelled using a
spirit level.
Use the appliance only when the covers
shown on diagram 19 in the Assembly
instruction are correctly assembled - risk of
injury.
ELECTRICAL WARNINGS
The rating plate is on the edge of the
dishwasher door (visible when the door is
open).
It must be possible to disconnect
the appliance from the power supply by
unplugging it if plug is accessible, or by
a multi-pole switch installed upstream of
the socket in accordance with the wiring
rules and the appliance must be earthed in
conformity with national electrical safety
standards.
Do not use extension leads, multiple
sockets or adapters. The electrical
components must not be accessible to
the user after installation. Do not use the
appliance when you are wet or barefoot.
Do not operate this appliance if it has a
damaged power cable or plug, if it is not
working properly, or if it has been damaged
or dropped.
If the supply cord is damaged, it must
be replaced with an identical one by the
manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard
- risk of electrical shock.
If the fitted plug is not suitable for your
socket outlet, contact a qualified technician.
Do not pull the power supply cable. Do not
immerse the mains cord or plug in water.
Keep the cord away from hot surfaces.
CLEANING AND MAINTENANCE
WARNING: Ensure that the appliance
is switched off and disconnected from
the power supply before performing any
maintenance operation. To avoid risk
of personal injury use protective gloves
(risk of laceration) and safety shoes (risk
of contusion); be sure to handle by two
persons (reduce load); never use steam
cleaning equipment (risk of electric shock).
Non-professional repairs not authorized
by the manufacturer could result in a
risk to health and safety, for which the
manufacturer cannot be held liable. Any
defect or damage caused from non-
professional repairs or maintenance will
not be covered by the guarantee, the terms
of which are outlined in the document
delivered with the unit.
6