- ページ 13

キッチン家電 Avantco 178UDD72HCのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Avantco 178UDD72HC 19 ページ。 Beer dispensers
Avantco 178UDD72HC にも：ユーザーマニュアル (19 ページ), ユーザーマニュアル (19 ページ)

ページを印刷する

Changing C02 Cylinder

Follow these instructions at ALL times when you replace a CO2 gas cylinder.

Close cylinder at A.

2. Remove tap D from keg. Pull pressure release ring on body of tap to release pressure remaining in line (do

not close C).

3. Remove or loosen regulator key B by turning counter clockwise.

4. Remove regulator from used cilinder at E.

5. Remove dust cap from new gas cylinder at E and clear dust from outlet by opening and closing valve A

quickly using appropriate wrench.

6. Attach regulator to new cylinder at E (use new fiber/plastic washer, if required).

Open valve A all the way.

8. Close valve C.

9. Adjust regulator key B by turning clockwise to set pressure (check setting by opening C and pulling and

releasing the ring F on the pressure release valve on the body of the tap).

10. Tap keg at D with valve C open.

NOTE: DO NOT drop cylinders. DO NOT lay cylinders flat. It requires 1/2 lb. of CO2 to dispense 1/2 barrel of

beer at 38°F with 15 lbs. of pressure on barrel.

Pressure Adjustment on CO2 Regulator

Increasing Pressure:

Close regulator shut-off C.

2. Turn regulator key B clockwise and make setting.

3. Tap gauge for accurate reading.

4. Open regulator shut-off C and draw beer.

Decreasing Pressure:

Close regulator shut-off C.

2. Untap keg at D and activate tap handle to bleed line.

Leave in open position.

3. Slowly open regulator shut-off C and simultaneously

turn regulator key counter-clockwise to zero reading.

4. Close regulator shut-off C and set pressure by turning

regulator key clockwise. Check setting by

opening and closing valve C.

5. Close tap head D (put in OFF position).

6. Tap keg at D and open regulator shut-off C.

User Manual

Beer Dispensers