- ページ 7

キッチン家電 Avantco UDD2448SのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Avantco UDD2448S 17 ページ。

Drain Instructions

On direct draws, the drain is located at the front of the cabinet .

(UDD1 & UDD1S drain into a bottle located inside the unit)

To plumb in the drain, connect ½" PVC pipe to the barbed fitting supplied with the unit .

If you would prefer to drain the beer inside the unit (for mobility or where a drain can't be found):

- Use a screwdriver to remove the drain bracket .

- Pull the drain hose so that it is inside the unit .

- Attach a bottle to the drain hose inside the unit .

- Plug the created hole at the bottom of the unit

- Temperature control set at No . 4 position gives refrigerators an approximate temperature of 35°F .

Allow unit to function several hours, completely cooling cabinet before changing the

control setting .

- Excessive tampering with the control could lead to service difficulties . Should it ever become

necessary to replace temperature control, be sure it is ordered from your Avantco dealer or

recommended service agent .

- Good air flow in your unit is critical . Be careful to load product so that it neither presses against

the back wall, nor comes within four inches of the evaporator housing . Refrigerated air off the coil

must circulate down the back wall .

Recommendation:

Before loading product, we recommend you run your Avantco unit empty for 2-3 days . This allows

you to be sure the electrical wiring and installation are correct and no shipping damage has

occurred . Remember, the Avantco factory warranty does not cover product loss!

Dial Controls (UDD1 & UDD1S ONLY)

Temperature range from (7) Coldest to (1) Warmest

Digital Controls (All Other Models)

Refrigerators are programmed to operate between 33 and 40°F

To set the temperature you would like your unit to run at:

1 . Hold "SET" for 1 sec . The display will flash the temperature

that the refrigerator is currently set to .

2 . Use the arrow buttons to adjust the temperature .

3 . Press "SET" to save your settings .

If the unit consistently runs 5+ degrees higher than your set

temperature, service may be needed .

Note: All other control functions should only be performed

by a trained service technician.

User Manual

- 7 -

Dial Controls

Digital Controls

set