ページを印刷する
Installation & Operation
Uncrating
If the unit has recently been transported on its side, please let the unit stand upright for a
minimum of 24 hours before plugging it in.
1 . Remove the outer packaging . All of the packaging (including cardboard, bubbles and plastic
wrap) should be removed from the unit .
2 . Move the unit as close to the final location as possible before removing the wooden pallet .
3 . Use a screwdriver to remove the screws
from the L-bracket connecting the unit to
the wooden pallet .
4 . Remove pallet by unscrewing all base rail
anchor brackets . Place pallet to the side .
5 . Carefully upright the cabinet .
Caution: When lifting unit
!
do not use the countertop
as a lifting point.
Locating
- Install the unit on strong and level surfaces, keep the cooler
stable to avoid vibration and noise .
- Install the unit in an indoor, well-ventilated area . A space of at
least 3" should be allowed between the surrounding walls and the
cabinet wall for air circulation .
- Unit should be placed far from any heating source to avoid
decrease of refrigeration efficiency .
- Install the cooler in a dry place to prevent rust from forming on
the compartment body, which may affect electrical insulation .
- The appliance shall not be exposed to rain or sun . Outdoor use
may cause decrease in efficiency and damage to the unit .
- The unit should be placed close enough to the electrical outlet
so that extension cords are never used .
Caution: Problems caused by improper
!
position of units are not covered by warranty
User Manual
- 3 -