- ページ 6

DVR HIKVISION DS-7104NI-K1/W/M(C)のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。HIKVISION DS-7104NI-K1/W/M(C) 20 ページ。

Safety Instruction

● Proper configuration of all passwords and other security settings is the responsibility of the

installer and/or user.

● In the use of the product, you must be in strict compliance with the electrical safety regulations

of the nation and region. Please refer to technical specifications for detailed information.

● Input voltage should meet both the SELV (Safety Extra Low Voltage) and the Limited Power

Source with 100 VAC to 240 VAC or 12 VDC according to the IEC60950-1 standard. Please refer

to technical specifications for detailed information.

● Do not connect several devices to one power adapter as adapter overload may cause over-

heating or a fire hazard.

● Please make sure that the plug is firmly connected to the power socket.

● If smoke, odor or noise rises from the device, turn off the power at once and unplug the power

cable, and then please contact the service center.

Preventive and Cautionary Tips

Before connecting and operating your device, please be advised of the following tips:

● Ensure recorder is installed in a well-ventilated, dust-free environment.

● Recorder is designed for indoor use only.

● Keep all liquids away from the device.

● Ensure environmental conditions meet factory specifications.

● Ensure recorder is properly secured to a rack or shelf. Major shocks or jolts to the recorder as a

result of dropping it may cause damage to the sensitive electronics within the recorder.

● Use the device in conjunction with an UPS if possible.

● Power down the recorder before connecting and disconnecting accessories and peripherals.

● A factory recommended HDD should be used for this device.

● Improper use or replacement of the battery may result in hazard of explosion. Replace with the

same or equivalent type only. Dispose of used batteries according to the instructions provided

by the battery manufacturer.

● When installing the device into a cabinet over 2U height, it is suggested to use rack shelf to bear

the weight. If the cabinet height is over 4U, it is suggested to use slide rails or rack shelf to bear

the weight.