- ページ 7

エンジン GAPOSA XQ Sileo XS 50のPDF マニュアルをオンラインで閲覧またはダウンロードできます。GAPOSA XQ Sileo XS 50 16 ページ。 Tubular motors with encoder electronic limits
GAPOSA XQ Sileo XS 50 にも：マニュアル (15 ページ)

ページを印刷する

ELECTRICAL CONNECTION

IMPORTANT INFORMATION FOR ELECTRICIANS

• It is possible to connect in parallel electronic motors to a switch in

residential applications where the total power cable length does

not exceed 10 meters. The number of motors paralleled together

is limited to 4-5 according to the switch total amperage capacity.

• Electronic motors cannot be paralleled connected together

when controlled by a Building Management system (BMS).

• Compatibility between electronic motors and BMS must be

approved and tested by manufacturer of BMS.

• For standard motor operation only a standard switch allowing either

UP or DOWN but not both at the same time must be used. Only

mechanically or electrically interlocked switches can be used.

• Motors with electronic limits can be connected in parallel. The

maximum load of the switch must never be exceeded.

• When changing from UP to DOWN or vice versa, the switchover time

must at least be 0.5 seconds and effected through an OFF position.

Only switches with a defined neutral position or one with a built-in

switching delay should be used.

• An "active path" control unit which monitors the current draw is in

conflict with the motor and cannot be used.

2/2