- ページ 6

サービス機器 Bernhard Rapid FacerのPDF ユーザーマニュアル/取扱説明書をオンラインで閲覧またはダウンロードできます。Bernhard Rapid Facer 15 ページ。 Bedknife front facing device

4. Setting Up

4.1

NOTE: The Rapid Facer RF1000 as shipped will need some minimal assembly before use.

Coloured

dots

Mount Plate / Magnet assemblies

to rail, coloured dot facing coloured

dot as shown above.

Socket cap screws may be

tightened using the 3mm allen key

provided.

To complete the assembly fit the

grinding head on to the slide unit.

4.2

PRELIMINARY CHECKS

4.2.1

Ensure that the air supply is not attached to the angle grinder motor.

4.2.2

Ensure that the eccentric pillars (parts 23 & 24) are correctly adjusted. They are set to

reduce backlash and allow free movement of the grinding head along the rail. These are

preset on new machines.

4.2.3

Ensure that the correct grade and size of grinding of disc (part 42) is fitted to the angle

grinder. This is factory supplied.

4.2.4

Ensure that the grinding disc (part 42) is concentric with the disc holder (part 41). This is

factory set.

4.2.5

Ensure that the grinding disc (part 42) is securely attached and that neither the disc nor the

disc holder (part 41) are damaged.

4.2.6

Ensure that the angle grinder (part 40) is securely attached to the carriage. Check that the

disc is set between the reel pins (part 39) and is free to rotate.

Mounting plates

and Magnet support

brackets

RAPID FACER MANUAL

M6 C'S'K

socket

screws

Rail