ページを印刷するTo start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing or removing the bit
CAUTION:
Install the bit securely. Always use only the wrench
•
provided with the tool. A loose or overtightened bit
can be dangerous.
Do not tighten the collet nut without inserting a bit or
•
install smaller shank bits without using a collet sleeve.
Either can lead to breakage of the collet cone.
1
005030
Insert the bit all the way into the collet cone and withdraw
it very slightly (approx. 2 mm). Press the shaft lock to
keep the shaft stationary and use the wrench to tighten
the collet nut securely. When using router bits with smaller
shank diameter, first insert the appropriate collet sleeve
into the collet cone, then install the bit as described above.
To remove the bit, follow the installation procedure in
reverse.
OPERATION
4
1
2
3
1. Workpiece
2. Bit revolving direction
3. View from the top of the tool
4. Feed direction
001984
1. Bit
2. Shaft lock
2
2
4
Set the tool base on the workpiece to be cut without the
bit making any contact. Then turn the tool on and wait
until the bit attains full speed. Move the tool forward
over the workpiece surface, keeping the tool base flush
and advancing smoothly until the cutting is complete.
When doing edge cutting, the workpiece surface should
be on the left side of the bit in the feed direction.
NOTE:
Moving the tool forward too fast may cause a poor
•
quality of cut, or damage to the bit or motor.
Moving the tool forward too slowly may burn and
mar the cut. The proper feed rate will depend on
the bit size, the kind of workpiece and depth of cut.
Before beginning the cut on the actual workpiece,
it is advisable to make a sample cut on a piece of
scrap lumber. This will show exactly how the cut
will look as well as enable you to check
dimensions.
When using the straight guide or the trimmer guide,
•
be sure to install it on the right side in the feed
direction. This will help to keep it flush with the
side of the workpiece.
2
1
001985
Straight guide
005031
The straight guide is effectively used for straight cuts
when chamfering or grooving.
5
1. Feed direction
3
2. Bit revolving
direction
3. Workpiece
4. Straight guide
4