- ページ 4
マーチャンダイザー Avantco 224BCAC36のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Avantco 224BCAC36 10 ページ。 36/48" black curved dual service refrigerated air curtain merchandiser - 110v
Avantco 224BCAC36 にも: ユーザーマニュアル (7 ページ)
Electrical
• Ensure that the required voltage is being supplied at all times.
• The unit should be plugged into a grounded and properly-sized electrical outlet with appropriate over-current
protection. Refer to the electrical requirements on the unit's nameplate.
• The unit should have its own dedicated outlet.
• DO NOT use extension cords.
• Ensure the unit is not resting on or against the electrical cord.
• If the unit is not in use for a long period of time, unplug from the outlet.
• To avoid shock and fire hazards, DO NOT plug in or unplug the unit with wet hands.
• After unplugging the unit, wait at least 10 minutes before plugging it back in. Failure to do so could cause
damage to the compressor.
Temperature Controls
Adjusting the Temperature
• Your new refrigerator is already factory-set to run at optimum temperatures for food safety and should require
no adjustments.
• Refrigerators are set to cycle between a minimum temperature of 33°F and a maximum temperature of 40°F.
• Adjusting the temperature changes the minimum temperature at which your unit will run. Your unit will not run
constantly at this setting. To change it, follow these instructions:
Digital Control Units
1. Hold "SET" for 1 second. The display will flash the
current minimum temperature.
2. Use the arrow buttons to adjust the minimum
temperature you'd like the unit to run at.
3. Press "SET" again to save your settings.
Always remember to calculate the differential if you
change the minimum temperature setting. The cabinet
temperature will fluctuate up to 7°F over your set
minimum temperature as the compressor runs and
shuts off. Setting the temperature too high will result
in unsafe maximum temperatures and possible health
code violations.
www.AvantcoRefrigeration.com
4
User Manual
Curved Dual Service Air Curtain Merchandisers
Controller #1
Controller #2