- ページ 7

電動工具 Makita 3706のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Makita 3706 17 ページ。 Cutout tool
Makita 3706 にも：取扱説明書 (14 ページ), 取扱説明書 (10 ページ), パーツマニュアル (2 ページ), 取扱説明書 (13 ページ), 取扱説明書 (12 ページ)

ページを印刷する

1. Bit

2. Collet nut

3. Shaft lock

4. Adapter

5. Wrench

6. Loosen

7. Tighten

OPERATION

•

When using the bit with 6.35 mm (1/4") shank diameter,

first remove the adapter from the collet cone, then install

the bit.

To install the bit, insert the bit all the way into the collet cone.

001626

Press the shaft lock to keep the shaft stationary and use the

wrench to tighten the collet nut securely.

To remove the bit, follow the installation procedure in reverse.

CAUTION:

•

Avoid forcing the bit to bend or twist. It may snap.

•

Before turning the tool on, make sure the bit and collet

nut are securely tightened.

Hold the tool secure with the bit pointing in a safe direction

001627

not contacting any surface and slide the switch to the ''ON''

position. Wait until the tool attains full speed.

When starting the multipurpose bit into the material, hold the

tool at approximately a 45 degree angle with the edge of the

shoe base contacting the material.

Carefully bring the tool to a straight position so the shoe

001628

base is in full contact with the material.