- ページ 8

電動工具 Makita 4131のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Makita 4131 12 ページ。 Metal cutter
Makita 4131 にも：取扱説明書 (12 ページ), 取扱説明書 (14 ページ), 取扱説明書 (12 ページ), 取扱説明書 (12 ページ)

ページを印刷する

Do not touch the saw blade, workpiece or cutting

•

chips with your bare hand immediately after

cutting, they may be extremely hot and could burn

your skin.

Always use the carbide-tipped saw blades

•

appropriate

for

inappropriate saw blades may cause a poor

cutting performance and/or present a risk of

personal injury.

Chip disposal

005355

CAUTION:

Always be sure that the tool is switched off and

•

unplugged before removing or installing the dust

cover.

The dust cover may become hot due to hot chips.

•

Do not touch the cutting chips or dust cover with

your bare hand.

When the cutting chips are visible through the sight

window, dispose of them.

Push and turn the knob clockwise to the

and remove the dust cover. Dispose of the cutting chips

accumulated inside the dust cover.

005347

CAUTION:

Do not turn the tool upside down. The cutting chips

•

accumulated inside the dust cover may fall out of

the dust cover.

Handle the dust cover carefully so that it will not

•

be deformed or damaged.

your

job.

The

use

1. Sight window

1. Dust cover

2. Knob

MAINTENANCE

CAUTION:

Always be sure that the tool is switched off and

•

unplugged before attempting to perform inspection

or maintenance.

Never use gasoline, benzine, thinner, alcohol or

•

the like. Discoloration, deformation or cracks may

result.

Inspecting saw blade

Check the blade carefully for cracks or damage

•

before and after each use. Replace a cracked or

damaged blade immediately.

Continuing to use a dull blade may cause a

•

dangerous

Replace with a new blade as soon as it no longer

cuts effectively.

Carbide-tipped saw blades for metal cutter

•

cannot be re-sharpened.

Replacing carbon brushes

symbol

001145

Remove and check the carbon brushes regularly.

Replace when they wear down to the limit mark. Keep

the carbon brushes clean and free to slip in the holders.

Both carbon brushes should be replaced at the same

time. Use only identical carbon brushes.

005356

Use a screwdriver to remove the brush holder caps.

Take out the worn carbon brushes, insert the new ones

and secure the brush holder caps.

To maintain product SAFETY and RELIABILITY, repairs,

any other maintenance or adjustment should be

performed by Makita Authorized Service Centers,

always using Makita replacement parts.

kickback

and/or

motor

1. Limit mark

1. Screwdriver

2. Brush holder

cap

overload.