- ページ 7

電動工具 Makita 4329のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Makita 4329 13 ページ。 Jig saw
Makita 4329 にも：取扱説明書 (13 ページ), 仕様 (2 ページ), 取扱説明書 (13 ページ), 技術情報 (7 ページ), 取扱説明書 (13 ページ)

ページを印刷する

Hex wrench storage

008085

When not in use, store the hex wrench as shown in the

figure to keep it from being lost.

Adjusting roller (For models 4326/4327)

008154

Loosen the bolt on the back of the base with the hex

wrench. Move the retainer so that the roller contacts the

blade lightly. Then tighten the bolt to secure the base

and the retainer.

NOTE:

Occasionally lubricate the roller.

•

Dust cover

008086

CAUTION:

Always wear safety goggles even when operating

•

the tool with the dust cover lowered.

Lower the dust cover to prevent chips from flying.

However, when making bevel cuts, raise it all the way.

1. Hook

2. Hex wrench

1. Blade

2. Roller

3. Retainer

4. Hex wrench

5. Bolt

6. Base

1. Dust cover

OPERATION

CAUTION:

Always hold the base flush with the workpiece.

•

Failure to do so may cause blade breakage,

resulting in a serious injury.

Advance the tool very slowly when cutting curves

•

or scrolling. Forcing the tool may cause a slanted

cutting surface and blade breakage.

Turn the tool on without the blade making any contact

and wait until the blade attains full speed. Then rest the

base flat on the workpiece and gently move the tool

forward along the previously marked cutting line.

008087

Bevel cutting

008088

CAUTION:

Always be sure that the tool is switched off and

•

unplugged before tilting the base.

Raise the dust cover all the way before making

•

bevel cuts.

With the base tilted, you can make bevel cuts at any

angle between 0° and 45° (left or right).

Loosen the bolt on the back of the base with the hex

wrench. Move the base so that the bolt is positioned in

the center of the cross-shaped slot in the base.

1. Cutting line

2. Base