- ページ 9

アンプ Garage1217 Project SolsticeのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Garage1217 Project Solstice 14 ページ。

Project

Solstice

INSTALLING THE SMD INDUCTOR

INSTALLING AN SMD DEVICE IS ACTUALLY QUITE SIMPLE – HOWEVER MANY WORRY THAT IT IS DIFFICULT. ALL YOU NEED TO DO IS

FOLLOW A FEW SIMPLE STEPS IN ORDER FOR THE INSTALLATION TO BE A SUCCESS.

1. TIN ONE OF THE SOLDER PADS COMPLETLEY SO SOLDER HAS FLOWED OVER THE ENTIRE PAD AS SHOWN. IT IS BEST TO POOL THE

SOLDER SLIGHTLY SO THAT IT IS RAISED OFF THE PCB

2. PLACE THE INDUCTOR OVER THE TOP OF THE SILKSCREEN LAYOUT ON THE CIRCUIT BOARD SO THAT ONE SIDE / PAD OF THE

INDUCTOR IS OVER THE SOLDER PAD YOU PREVIOUSLY HAVE TINNED. WHILE PRESSING DOWN ON THE INDUCTOR, HEAT THE SOLDER

PAD THAT YOU PREVIOUSLY HAVE TINNED SO THAT SOLDER MELTS. YOU WILL FEEL THE INDUCTOR SLIGHTLY SINK INTO THE SOLDER.

MAKE SURE THE INDUCTOR IS SQUARE ON THE PCB PRIOR TO REMOVING HEAT AND LETTING COOL.

3. ONCE SOLDER HAS COOLED AND THE INDUCTOR IS SECURE, HEAT THE OTHER SOLDER PAD NEXT TO THE INDUCTOR AND ADD

SOLDER SO THAT IT MELTS AND FLOWS / SOLDERING THE INDUCTOR TO THE PCB.