- ページ 7

ケーブルとコネクター CORNING PCH-02UのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。CORNING PCH-02U 10 ページ。

4.5

Managing Cable

WARNING: Never look directly into the end of a fiber that may be carrying laser light.

Laser light can be invisible and can damage your eyes. Viewing it directly does not cause pain.

The iris of the eye will not close involuntarily as when viewing a bright light. Consequently,

serious damage to the retina of the eye is possible. Should accidental eye exposure to laser

light be suspected, arrange for an eye examination immediately.

WARNING: DO NOT use magnifiers in the presence of laser radiation. Diffused laser light

can cause eye damage if focused with optical instruments. Should accidental eye exposure to

laser light be suspected, arrange for an eye examination immediately.

Step 1:

Remove the blank panels from the unit and replace with connector panels

(purchased separately).

Step 2:

Clean connectors and adapters as described in Section 5.

Step 3:

Install connectors into the adapters at the rear of the connector panels.

Step 4:

Route cable slack around radius control guides (Figure 9).

Step 5:

Cut the provided hook-and-loop strap into two pieces and feed the two straps into the

slots at the rear of the housing. Use the straps to secure fibers as needed.

IMPORTANT: Lift the tray stop latches and slide the drawer backward and forward to verify that the

drawer slides in the grooves of the guides and that there is enough fiber slack to prevent

violating the minimum fiber bend radius of the cable.

Cable tie

STANDARD RECOMMENDED PROCEDURE 003-722 | ISSUE 4 | OCTObER 2015 | PAGE 7 OF 10

KPA-0154

Hook-and-loop straps

Figure 9