コントロールユニット GARAN EWS-102のPDF システム設定をオンラインで閲覧またはダウンロードできます。GARAN EWS-102 4 ページ。
GARAN EWS-102 にも：システム設定 (4 ページ), キャリブレーションとセットアップ (8 ページ), 補足情報 (2 ページ), システム設定 (4 ページ)

ページを印刷する

EWS-102 CONTROL UNIT

To begin the system

setup, press the

buttons together.

Enter the system setup menu.

Select the first menu item.

CAP

AL 1

AL 2

AL 3

hyst

dLy

diSP

FIL

bEEP

5rES

Firmware 2.5 Rev 1 subject to alteration

and

CAL

SYST

CAP indicates the elevator maximum capacity. To view the current value press

AL 1 is the load value to trigger Alarm Relay 1. To view the current value press

AL 2 is the load value to trigger Alarm Relay 2. To view the current value press

AL 3 is similar to Alarms 1 & 2 but allows negative values to be entered. When editing the

most significant digit, instead of rolling over from 9 to 0 it included the minus sign option.

Defines the value by which the load in the lift has to drop to reset the instrument,

once the alarm has been triggered.

Defines the time from the control signal input is activated and the car load is stored.

Default =2, the available settings are: 0 = 0sec, 1 = 0.5sec, .....7 = 3.5sec.

Op�on for turning the display on or off when the li� is moving, the door close signal

ac�vates. To change the setting, press

The filter value determines the update rate and damping factor. The available settings are:

0 = 0.4sec, 1 = 0.8sec, 2 = 1.2sec, 3 = 1.6sec.

An internal sounder beeps when an overload alarm is triggered or when the keypad is pressed.

To change the setting, press

Op�on to turn the systems reset func�on on or off. Leave OFF during system set up and zero and

load calibra�on. Select ON a�er calibra�on and before entering the li� into service.

To change the setting, press

Save and return to normal operation by pressing

The system setup menu allows you to set and adjust various

system parameters.

Naviga�on

Use the

bu�on to step through the menu items.

Press

to view the menu item

Edi�ng Values

When a value is displayed, use

edit (selected digit flashes) and use

values for that digit.

Press

to save a change. The system will revert to the

opera�onal display a�er approx. 10 seconds. Alterna�vely,

return to the opera�onal display by pressing

Notes

To calibrate the EWS 102, a link must be fi�ed to the control

signal input terminals

Un�l a sensor is connected, the EWS will display Err6

preven�ng access to the system setup and calibra�on menus

For further informa�on refer to EWS 102 User Manual

and use

To toggle between On and OFF.

and use

To toggle beteween On and OFF.

and use

To toggle beteween On and OFF.

twice

www.garan.co.uk

SYSTEM SETUP

to select the digit to

to step through the

twice

Page 1