- ページ 6

ツール CORNING Universal Access Tool 3のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。CORNING Universal Access Tool 3 9 ページ。
CORNING Universal Access Tool 3 にも：取扱説明書 (18 ページ)

ページを印刷する

7.3

With initial blade depths set and the thumbscrew loosely tightened, advance

the tool approximately 6 inches (15.24 cm) by turning the handle in the direction of

the arrow marked on the tool.

Figure 12

7.4

After approximately

inches (15.24 cm) of travel check the depth of the cuts

(Figure

13)./fthe blades have not penetrated the tube, skip to step 7.6.

7.5 If

either blade has penetrated the tube, then rotate the respective blade's

coarse adjustment cOllilterclockwise (to reduce blade depth) to the previous

0.2

increment (see Figure

13,

inset) and advance the tool another

inches. Recheck the

of cut and repeat process until the blades are no longer penetrating the cen

tube.

Lt.

CAUTION: Care must be taken when checking the bottom cut. The natural

tenrkncy

to rotate the tool/tube; however, this places a sirk, load on the cutting blades

which can result in blark breakage. It

recommenrkd to lift the tool/tube to see the bot

tom cut or hold the tube ahead ofthe tool and rotate it with the tool to trooid damage to

the cutting blades.

Figure 13

SRP-004-074

7.6 To complete the final blade

adjustment:

a) With both blades scoring, but not penetrating the central tube,

rotate the fine adjustment wheels clockwise to increase the

blade depths (Figure 14).

Figure 14

Advance the tool

inches and recheck the depths of the cuts.

Repeat this process lmtil either the blades are slitting the central tube or the fine

adjustment wheels have

re~ched

their maximum.

the

adjustments are "maxed" out before the central

tube is slit, then return the fine adjustment to its minimum

setting (fully cOlmterclockwise) and turn the coarse adjust

ment wheel clockwise (increasing blade depth) to the next

0.2

mm increment (Figure

15).

Figure 15

c) Repeat this adjustment process lliltil both blades just slit the central tube. Once a

blade has penetrated a central tube, retract the blade slightly so that it no

longer slits the central tube, but scores it without slitting it. "When properly

scored, but not penetrated, the tubes should easily peel apart.

Using the

Tool

7.7

With the blade depths set, turn the handle to advance the tool to the end of

the cut (Figure

16).

Figure 16

SRP-004-074