- ページ 4

ラック＆スタンド CORNING EDGE8 SeriesのPDF マニュアルをオンラインで閲覧またはダウンロードできます。CORNING EDGE8 Series 11 ページ。 Single-module housing
CORNING EDGE8 Series にも：インストール (4 ページ)

ページを印刷する

Step 4:

Reinstall all floor tiles with the panel-lifter tool. Ensure tiles are even with adjacent tiles. If the

floor tile over the FZB will not lay flat and even, it may be necessary to install the box below

the stringers as described in Section 4.2.3.

4.2.2 Alternative Method 1

If unable to successfully install the unit under a raised floor following the instructions in Section 4.2.1:

Step 1:

Remove one of the trim plates and reinsert the housing into the center opening. Allow the

side where the trim plate was removed to drop below the stringer on that side (Figure 7).

STANDARD RECOMMENDED PROCEDURE 003-825-AEN | ISSUE 7 | NOVEMBER 2020 | PAGE 4 OF 11

Figure 6

Figure 7