- ページ 6

電動工具 Makita 9910のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Makita 9910 8 ページ。 76mm
Makita 9910 にも：部品内訳 (3 ページ), 取扱説明書 (17 ページ), 部品内訳 (3 ページ), 取扱説明書 (13 ページ), 取扱説明書 (8 ページ), 技術情報 (5 ページ), 取扱説明書 (17 ページ)

ページを印刷する

Switch on the tool and make sure that the belt is aligned

properly. If the edge of the belt extends beyond the edge

of the steel plate or the edge of the belt retracts more

than 8 mm away from the edge of the steel plate, use the

adjusting screw to adjust the belt tracking.

Dust bag

003387

Attach the dust bag onto the dust spout. The dust spout

is tapered. When attaching the dust bag, push it onto the

dust spout firmly as far as it will go to prevent it from

coming off during operation.

When the dust bag is about half full, remove the dust

bag from the tool and pull the fastener out. Empty the

dust bag of its contents, tapping it lightly so as to remove

particles adhering to the insides which might hamper

further collection.

NOTE:

If you connect a Makita vacuum cleaner to this tool,

•

more efficient and cleaner operations can be

performed.

Connecting to Makita vacuum cleaner

004050

Cleaner sanding operations can be performed by

connecting the belt sander to Makita vacuum cleaner.

When connecting to Makita vacuum cleaner, an optional

hose 28 mm in inner diameter is necessary.

1. Dust spout

2. Dust bag

1. Optional hose

28 mm in inner

diameter

2. Hose of vacuum

cleaner

3. Vacuum cleaner

OPERATION

Sanding operation

004232

CAUTION:

The tool should not be in contact with the

•

workpiece surface when you turn the tool on or off.

Otherwise a poor sanding finish or damage of the

belt may result.

Hold the tool firmly with both hands. Turn the tool on and

wait until it attains full speed. Then gently place the tool

on the workpiece surface. Keep the belt flush with the

workpiece at all times and move the tool back and forth.

Never force the tool. The weight of the tool applies

adequate pressure. Excessive pressure may cause

stalling, overheating of the motor, burning of the

workpiece and possible kickback.

Clamps (optional accessory)

This machine can be operated in the inverted position.

To do so, secure the machine to a stable workbench with

two clamps.

004140

MAINTENANCE

CAUTION:

Always be sure that the tool is switched off and

•

unplugged before attempting to perform inspection

or maintenance.

Never use gasoline, benzine, thinner, alcohol or

•

the like. Discoloration, deformation or cracks may

result.

1. Clamps