- ページ 7

電動工具 Makita 9911のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Makita 9911 13 ページ。 76mm
Makita 9911 にも：取扱説明書 (17 ページ), 部品内訳 (3 ページ), 取扱説明書 (8 ページ), 取扱説明書 (8 ページ), 技術情報 (5 ページ), 取扱説明書 (17 ページ)

ページを印刷する

OPERATION

1. Clamps

MAINTENANCE

1. Limit mark

1. Screwdriver

2. Brush holder cap

Sanding operation

004232

CAUTION:

•

The tool should not be in contact with the workpiece surface when you

turn the tool on or off. Otherwise a poor sanding finish or damage of the

belt may result.

Hold the tool firmly with both hands. Turn the tool on and wait until it attains full

speed. Then gently place the tool on the workpiece surface. Keep the belt

flush with the workpiece at all times and move the tool back and forth.

Never force the tool. The weight of the tool applies adequate pressure. Exces-

sive pressure may cause stalling, overheating of the motor, burning of the

workpiece and possible kickback.

Clamps (optional accessory)

This machine can be operated in the inverted position. To do so, secure the

004140

machine to a stable workbench with two clamps.

CAUTION:

•

Always be sure that the tool is switched off and unplugged before

attempting to perform inspection or maintenance.

Replacing carbon brushes

001145

Remove and check the carbon brushes regularly. Replace them when they are

worn down to the limit mark. Keep the carbon brushes clean and free to slip in

the holders. Both carbon brushes should be replaced at the same time. Use

only identical carbon brushes.

Use a screwdriver to remove the brush holder caps. Take out the worn carbon

003398

brushes, insert the new ones and secure the brush holder caps.