- ページ 3

カードリーダー E-Service PayterのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。E-Service Payter 9 ページ。 Wireless card reader

Payter Installation Guide

3. Enable 10p coins for testing

On the large circuit board opposite to where the software was fitted, locate the four

switches marked 'S2', as seen circled in red in figure 3. Flip the fourth switch to the on

position.

figure 3

4. Test the newly activated software

Test the software by dropping a 10p coin, it should give change for the same value that the

Contactless tap value should be, i.e £5, £10 or £20. Insert all other coins and notes and check

the change given is correct.

If the change given is correct, close the control module, re-insert the note validator and

proceed to section 5. If the change is incorrect or you encounter other errors, replace the

old software chip and call E-Service support on 01707 280 050.

5. Close the Control Module

Close the Control Module, reposition the note validator and screw back into place.