- ページ 6

電動工具 Makita BDA340のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Makita BDA340 9 ページ。 Cordless angle drill
Makita BDA340 にも：取扱説明書 (13 ページ), 取扱説明書 (8 ページ), 技術情報 (7 ページ)

ページを印刷する

Reversing switch action

008954

This tool has a reversing switch to change the direction

of rotation. Depress the reversing switch lever from the A

side for clockwise rotation or from the B side for

counterclockwise rotation.

When the reversing switch lever is in the neutral position,

the switch trigger cannot be pulled.

CAUTION:

Always check the direction of rotation before

•

operation.

Use the reversing switch only after the tool comes

•

to a complete stop. Changing the direction of

rotation before the tool stops may damage the tool.

When not operating the tool, always set the

•

reversing switch lever to the neutral position.

ASSEMBLY

CAUTION:

Always be sure that the tool is switched off and the

•

battery cartridge is removed before carrying out

any work on the tool.

Installing side grip (auxiliary handle)

008956

CAUTION:

Always be sure that the side grip is installed

•

securely before operation.

Screw the side grip on the tool securely. The side grip

can be installed on either side of the tool, whichever is

convenient.

1. Reversing

switch

Installing or removing drill bit

008957

To install the bit, place it in the chuck as far as it will go.

Tighten the chuck by hand. Place the chuck key in each

of the three holes and tighten clockwise. Be sure to

tighten all three chuck holes evenly.

To remove the bit, turn the chuck key counterclockwise

in just one hole, then loosen the chuck by hand.

After use, return the chuck key to the storage cavity on

the tool.

Chuck key holder

008959

To install the chuck key holder, fix it to the convex portion

of the tool housing on either side and then secure it with

a screw. To remove, loosen the screw and then take it

out.

Hook

008958

The hook is convenient for temporarily hanging the tool.

This can be installed on either side of the tool.

To install the hook, insert it into a groove in the tool

housing on either side and then secure it with a screw.

To remove, loosen the screw and then take it out.

1. Chuck key

holder

2. Screw

1. Groove

2. Hook

3. Screw