- ページ 16
電動工具 Makita BFH090FのPDF 技術情報をオンラインで閲覧またはダウンロードできます。Makita BFH090F 18 ページ。 Makstar 12v cordless screwdrivers
ページを印刷する
2. After connecting flag receptacles, set Terminal in place on Housing R, and put the lead wires
(black one and red one), which connect Terminal to Motor control unit, on the lead wires from
Interlock switch unit illustrated in Fig. G.
And then apply gentle pressure to lead wires (black one and red one) in order to hold down the lead wires which
is laid under them.
Fig. G
(5) Wiring around clutch case
Put the lead wire of clutch switch unit as illustrated in Fig. H
Fig. H
Top view of clutch switch unit
Clutch switch unit
< Note >
Make sure that spacer has been mounted
to housing R, before setting terminal.
Refer to Fig. 49 in page 10.
Red lead wire which connects Terminal
to Motor control unit
And black one
Terminal
Lead holder
Pin
Clutch case
Pass the lead wires, covered by shrink tube,
through the pin.
And hold them with lead holders at clutch case.
Contain the slack portion
of lead wires and connectors
into this pace.
P 16 / 17