- ページ 2

懐中電灯 Bernzomatic BZMTS99TのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Bernzomatic BZMTS99T 3 ページ。 High-temperature torches

• When thawing pipes, be very careful not to overheat surrounding materials. Use heat shield.

• Always have a fire extinguisher and a bucket of water near the torch and work area.

• This torch consumes oxygen and must only be used in well ventilated areas. Do not use in a confined space.

• Never attempt to light the torch with a setting that would result in a main flame less than one quarter inch (1/4") long.

An excessively short flame will cause lighting difficulties, will result in inefficient heating and may damage the ignition

mechanism.

DANGER

EXTREMELY FLAMMABLE. CONTENTS UNDER PRESSURE.

• Keep fuel cylinders away from heat or flame.

• It is illegal and dangerous to refill the cylinder. When empty, obtain a new cylinder from your dealer.

• Federal law prohibits transportation if refilled. Penalty up to $500,000 fine and five years imprisonment (49 U.S.C. 5124)

• Keep cylinders out of reach of children

• Avoid prolonged exposure to sunlight.

• Do not store near source of heat or in a room used for habitation.

• Always detach torch from cylinder when not in use.

• Do not breathe gas, fumes, vapor or spray. If inhaled, remove affected person to fresh air.

• Avoid contact with eyes or skin. In case of contact with eyes, rinse immediately with plenty of water and seek medical

advice. For skin contact, flush with large amounts of water.

• When cylinder is empty, discard in a safe place. Do not throw cylinder in fire. Do not puncture or incinerate cylinder.

COMPONENTS

TS99

TO ADJUST

ADJUSTMENT KNOB

REGULATOR

TS839

TO ADJUST

BURN TIP

IGNITION

BUTTON

ASSEMBLY

1. Make sure regulator valve is off by turning adjustment knob clockwise until it stops. A light stop is sufficient.

Do not force.

2. Hold torch so that burn tube is pointed away from persons and highly flammable materials.

Thread gas cylinder into regulator/torch body. Hand tighten only. Do not force.

3. Check all joints and couplings periodically to insure against loose connections. With valve closed, without lighting, test

all connections with soapy water. If bubbles appear, gas is leaking and torch must be repaired or replaced. Never use a

flame to check for leaks. Make this test in a well ventilated and spark-free area and where there are not open flames.

BURN TIP

IGNITION

BUTTON

TORCH BODY

CONNECT TO CYLINDER

ADJUSTMENT KNOB

REGULATOR

CONNECT TO CYLINDER

DO NOT DISCARD THESE WARNINGS AND INSTRUCTIONS

BZ4600SW

TO ADJUST

ADJUSTMENT KNOB

REGULATOR

JT539

TO ADJUST

BURN TIP

CONNECT TO CYLINDER

ADJUSTMENT KNOB

REGULATOR

CONNECT TO CYLINDER