- ページ 5

レンジ KitchenAid GAS RANGEのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。KitchenAid GAS RANGE 10 ページ。 30" freestanding gas range with standard clean oven

ページを印刷する

1. Gas Connection

Operating

position

protect floor covering.

Before

moving

range

across

floor,

check that

range is still on cardboard shipping base to

front leveling leg

Carefully

move range into

final operating

position. Check that

rear leveling leg is

Place rack in oven. Place level on rack,

first side to side; then front to back.

engaged in anti-tip

bracket.

If range is not level, pull range forward until

rear leveling leg is removed from the anti-tip

bracket. Use 3/8' drive ratchet and channel

lock pliers to adjust leveling legs up or down

Remove cardboard shipping base

until range is level. Push range back into

under range. Open broiler door. Use a 3/8"

If installing the range in a mobile

drive ratchet to lower rear leveling legs one-

home, you MUST secure the range to the floor.

position. Check that rear leveling leg is

half turn. Use channel lock pliers to lower front

Any method of securing the range is adequate

engaged in anti-tip bracket.

leveling legs one-half turn.

as long as it conforms to the standards in the

Note: Oven must be level for satisfactory

"Mobile home installation"

instructions, Page 1.

baking conditions.

Gas connection

All connections must be wrench-tightened.

Use a brush and liquid detergent

Typical

rigid pipe connection

to test all gas connections. Bubbles around

connections will indicate a leak. If a leak

appears, shut off gas valve controls and

tighten connections. Then check connections

again. Never test for gas leaks with a match

or other flame. Clean all detergent from

range. Replace broiler door.

Fire Hazard

Do Not make connection too tight. The

regulator is die cast. Making the

connection too tight may crack the

Check that all control knobs are in

the "OFF" position.

regulator, resulting in a gas leak and

possible explosion or fire.

Do Not use an open flame to test for leaks

from gas connections.

Typical

flexible

connection

match near both pilot

light housings to light the

pilot lights. Adjust pilot adjustment screw

connector

until pilot flame tips are l/8' high and

centered in the pilot housings. If the flame is

too high, carbon (soot) will form on

underside of maintop.

adapter -

Lift cooktop maintop until it is held in

-!a

manual

place by support rods. Locate pressure

gas

shutoff

regulator.

112" to 314"

valve

gas pipe

maximum length 21-l/2"

A l/2" male pipe thread is needed for connection to

pressure regulator female pipe threads.

Assemble the flexible connector

from the gas supply pipe to the pressure

Open broiler door. Hold a match

regulator.

to the opening in the top of the pilot area at

the rear of the oven burner. No pilot

adjustments are needed. Close broiler door.

Use pipe-joint compound made for

use with L.P. gas to seal all gas connections.

If flexible connectors are used, be certain

connectors are not kinked.

manual shutoff valve

Open the manual shutoff valve in the

gas supply line. Wait a few minutes for gas to

move through the gas line.