- ページ 10

電動工具 Makita BHS630のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Makita BHS630 13 ページ。
Makita BHS630 にも：技術情報 (16 ページ)

ページを印刷する

012149

When you wish to perform clean cutting operation,

connect a Makita vacuum cleaner to your tool. Install the

dust nozzle on the tool using the screw. Then connect a

hose of the vacuum cleaner to the dust nozzle as shown

in the figure.

OPERATION

CAUTION:

Always insert the battery cartridge all the way until

•

it locks in place. If you can see the red part on the

upper side of the button, it is not locked completely.

Insert it fully until the red part cannot be seen. If not,

it may accidentally fall out of the tool, causing injury

to you or someone around you.

Be sure to move the tool forward in a straight line

•

gently. Forcing or twisting the tool will result in

overheating the motor and dangerous kickback,

possibly causing severe injury.

If the tool is operated continuously until the battery

•

cartridge has discharged, allow the tool to rest for

15 minutes before proceeding with a fresh battery.

012108

Hold the tool firmly. The tool is provided with both a front

grip and rear handle. Use both to best grasp the tool. If

both hands are holding saw, they cannot be cut by the

blade. Set the base on the workpiece to be cut without

the blade making any contact. Then turn the tool on and

wait until the blade attains full speed. Now simply move

the tool forward over the workpiece surface, keeping it

flat and advancing smoothly until the sawing is

completed.

1. Hose

2. Vacuum cleaner

To get clean cuts, keep your sawing line straight and your

speed of advance uniform. If the cut fails to properly

follow your intended cut line, do not attempt to turn or

force the tool back to the cut line. Doing so may bind the

blade and lead to dangerous kickback and possible

serious injury. Release switch, wait for blade to stop and

then withdraw tool. Realign tool on new cut line, and start

cut again. Attempt to avoid positioning which exposes

operator to chips and wood dust being ejected from saw.

Use eye protection to help avoid injury.

Rip fence (Guide rule)

012109

The handy rip fence allows you to do extra-accurate

straight cuts. Simply slide the rip fence up snugly against

the side of the workpiece and secure it in position with

the clamp lever on the front of the base. It also makes

repeated cuts of uniform width possible.

MAINTENANCE

CAUTION:

Always be sure that the tool is switched off and the

•

battery cartridge is removed before attempting to

perform inspection or maintenance.

Never use gasoline, benzine, thinner, alcohol or

•

the like. Discoloration, deformation or cracks may

result.

Adjusting for accuracy of 90°cut (vertical cut)

012102

1. Clamp lever

2. Rip fence

(Guide rule)

1. Adjusting screw

2. Wing screw