- ページ 13

潤滑システム BEROTEC MofessorのPDF マニュアルをオンラインで閲覧またはダウンロードできます。BEROTEC Mofessor 16 ページ。 Automatic chain lubrication system
BEROTEC Mofessor にも：マニュアル (16 ページ), ユーザーマニュアル (12 ページ)

ページを印刷する

Manual

Operation and Maintenance

5.1

Adjusting the Oil Flow

We recommend to initially set the rotary switch to level 1. This is the

setting for minimal oil flow. After 5 miles, check the amount of oil on

the chain and the whole system to ensure there is no malfunction.

After another 50 miles, start adjusting the rotary switch for a higher oil

flow. Find the optimal setting by turning the rotary switch step by step.

Keep in mind, changes in the oil flow need around 150 miles before a

valid evaluation is possible.

By following this procedure, soiling of the motorbike can be avoided.

Adjusting a high flowrate of chain oil can lead to the soiling of the rear

wheel. The oil flow has to be reduced immediately. A closed lubricity

on the chain rollers is sufficient and important.

The driver is responsible for a correct amount of oil. We are not liable

for damages caused by the oil flow being too low or too high.

Level

Figure 4: Adjusting the Oil Flow

MOFESSOR

BEROTEC GmbH

P a g e

| 12