- ページ 5

IPカメラ ALIBI ALI-TS2015RのPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。ALIBI ALI-TS2015R 5 ページ。 5mp hd-tvi 135 ir varifocal outdoor turret camera

ページを印刷する

AGC

Support

D/N Mode

Auto / Color/ BW (Black and White)

White Balance

ATW / MWB

BLC

Support

Digital Wide Dynamic Range (DWDR)

Support

Language

English. Chinese

Functions

Brightness, Sharpness, Digital noise reduction, Mirror, Smart IR

General

-40°F ~ 140°F (-40°C ~ 60°C), Humidity 90% or less (non-condensing)

Operating Conditions

Power Supply

12 Vdc ±25%

Power Consumption

Max. 9 W

Protection Level

IP67

Material

Metal

IR Range

Up to 135 ft (40 m)

Communication

Up the coax (HD-TVI output)

Dimensions

5.29" × 4.88" × 4.38" (34.3 mm × 123.9 mm × 110.1 mm)

Weight

1.57 lb (750 g) approx.

Cleaning

Clean the camera dome with an approved glass cleaning solution and a lint free cloth.

Dust can be removed from the unit by wiping it with a soft damp cloth. To remove stains, gently rub

•

the surface with a soft cloth moistened with a mild detergent solution, then rinse and dry it with a

soft cloth.

Remove all foreign particles, such as plastic or rubber materials, attached to the camera housing.

•

These may cause damage to the surface over time.

Do not use benzene, thinner or other chemical products on the camera assembly; these may



dissolve the paint and promote damage of the surfaces. Before using any chemical product,

CAUTION

carefully follow the accompanying instructions.

Troubleshooting

Problem

Possible Cause

Nothing appears on the screen

- Check the power connection.

- Check the video signal cable connection to the monitor.

- Check HD-TVI DVR camera settings to verify the video resolution mode of the

camera and HD-TVI DVR match

The video image is dim or not clear.

- If the camera lens is dirty, clean it with a soft, clean cloth.

- Adjust the monitor controls, if necessary.

- If the camera is facing a very strong light, change the camera position.

- Adjust the lens focus.

The screen is dark.

- Adjust the contrast control of the monitor.

- If you have an intermediate device, set the impedance (75 Ω /Hi-Z)

properly, and check the cable connections.

The camera is not working properly and

- Verify that the camera is correctly connected to an appropriate regulated

the surface of the camera is hot.

power source.

The image on the monitor flickers

- Make sure that the camera isn't facing direct sunlight or fluorescent light.

If necessary,change the camera position.