- ページ 10

ネットワーク・ハードウェア ALIBI ALI-NVR3104PのPDF クイック・セットアップ・マニュアルをオンラインで閲覧またはダウンロードできます。ALIBI ALI-NVR3104P 12 ページ。

HDD 1 SATA

Back

cable connector

Front panel

HDD 1 bay

cables (2)

HDD power

cables (2)

Remove the tape securing the front panel cables are taped to the bottom of the chassis. Usually two strips of tape are used to hold

down the cables.

Unpackage the HDD. In the photo below, note the location of the HDD mounting screw holes on the underside of the HDD. Also shown

are the SATA and Power cable connectors.

SATA cable

connector

Power cable

connector

Screw the four HDD mounting screws into the mounting screw holes until the screw heads are about 1/8 inch from the surface bottom

of the HDD.

Follow recommended electrostatic discharge (ESD) guidelines while performing this procedure. Install the HDD in a static-free

environment, wearing a certified ESD wrist strap. If a static free environment and ESD wrist strap is not available, touch the bare metal of



the DVR chassis frequently when installing the drive to dissipate the static charge naturally generated on your skin and clothing and avoid

CAUTION

touching electronic components.

www.Observint.com

HDD 2 SATA

cable connector

PC board

Slots for HDD

mounting

screws (2 x 4)

HDD 2 bay

HDD mounting

screw holes

Position the HDD in HDD 1 bay under the front panel cables such that the HDD cable connectors are toward the middle of the chassis

and the HDD mounting screws are fully seated in the mounting screw slots.

While holding the HDD in place, carefully turn over the chassis with the HDD and then tighten the mounting screws to secure the HDD.

Be careful not to overtighten the screws.

Turn the chassis over so the top is up.

10.

Attach the HDD SATA cable to the HDD 1 SATA cable connector on the PC board, and then to the SATA connector on the HDD. When the

connector is fully seated, it clips into place.

11.

Attach the HDD power cable to the power cable connector on the HDD.

HDD 1 mounting screws